Dibond signs
Printed aluminium composite panels for signs that need to stay flat, rigid and presentable outdoors for a long time.

Dibond is a brand of aluminium composite material, often shortened to ACM. Each panel is two thin sheets of aluminium bonded to a solid plastic core. You get the rigidity and weather resistance of metal at a fraction of the weight of solid aluminium, and the surface is flat enough for a sharp, full-colour print.
Signs that suit Dibond
- Shopfront and fascia panels
- Business name plates and entrance signs
- Car park, directional and information signs
- Construction site and safety boards
- Hoarding panels and exterior display boards
- Interior signs where a premium, flat finish matters
Dibond compared with other boards
We mount prints on Foamex, polyboard, Dibond, MDF and Correx, so we can be straightforward about which one to use.
Against Foamex: Foamex is lighter and good for indoor signs and short-term outdoor use, but large Foamex panels can bow in heat and cold over time. Dibond stays flat. If a sign is outdoors and meant to stay up, Dibond is usually the better board.
Against Correx: Correx is a temporary material, for signs measured in weeks rather than years. Dibond is for signs you want to forget about once they are up.
Against solid metal: we can print and mount onto metal for rigid work, but for most signs aluminium composite gives the same look with less weight.
Print and finish
We print outdoor work with UV-resistant inks, and signs can be laminated for protection against weather, scratches and graffiti. Where a special colour is needed, coloured vinyl can be applied. Cut vinyl lettering is an option for simple text signs. Tell us how the sign will be fixed: screws through the face, hidden fixings on the back, or a frame or post system.
Artwork advice
- Size text for the reading distance. A sign read from a car park entrance needs much larger lettering than a door plate.
- Allow for fixings. If the sign will be screwed through the face, leave clear space in each corner.
- Bleed and safe area. Run backgrounds past the trim edge and keep text well inside it.
- Use vector logos. Supply logos and lettering as vector artwork so the edges stay sharp at any size.
If you only have a logo and the wording, our designers can draw up the sign.
Long-term signs, planned properly
Because a Dibond sign is meant to stay up for years, a little planning at the start pays off. Check the wording carefully, especially phone numbers and web addresses that might change. Consider whether part of the information is better on a separate, cheaper panel that can be replaced. And think about what the sign is fixing to: a sound wall, a post, a fence or a frame.
Supply and fit
We design, print and install. Send the size, the wording or artwork and the location of the sign. Request a quote or send your artwork.
Questions
Is Dibond the same as aluminium composite?
Dibond is a well-known brand of aluminium composite material. You may also see it called ACM or alupanel.
Will a Dibond sign rust?
Aluminium does not rust in the way steel does, which is one reason it is used for outdoor signs.
Can you fit the sign as well?
Yes, our own team installs. Tell us where the sign is going and what it is fixing to.
Can I have a sign printed on both sides?
Ask us when you request a quote. Double-sided signs are possible, depending on how the sign is mounted.
Tell us what you need printed
Give us the size, the material and the date you need it. We will check your files and send a quote.
0203 026 0636